Installation - Convertible

INSTALLATION - CONVERTIBLE




1. Position each header end molding to the inside of the windshield opening frame and if equipped, route the wire harness connector for the illuminated sun visor through the hole in the molding.

2. Install each header end molding onto the windshield opening frame. Make sure the snap retainers are fully engaged to the windshield opening frame.





3. Position the header center molding to the inside of the windshield opening frame.

4. Install the header center molding onto the windshield opening frame. Make sure the snap retainers are fully engaged to the windshield opening frame and if equipped, the wire harness connector is positioned in the notch of the molding.

5. Install the sun visor and sun visor retainer.