Installation

INSTALLATION




1. Position the convertible top wire harness into the vehicle.

2. Connect the convertible top wire harness connector (2) to the body wire harness connector (3).

3. Route the rear window defogger wire lead (1) through the wire slings and connect the wire connectors to the rear window defogger terminals.





4. Connect the convertible top wire harness (3) to the pump motor (1).

5. Install the three retaining clips that secure the convertible top wire harness and relay (2) to the body.





6. Install the protective cover (3) to the top of the hydraulic pump/motor assembly (4) located on the shelf panel.





7. Position the convertible top well liner (2) into the vehicle and install the push-pins (1) that secure the liner to the rear seat back panel (3) and body (4).

8. Install the rear seat back.

9. Install the left interior quarter trim panel.

10. Install the rear seat cushion.