Removal

REMOVAL





WARNING: The normal operating temperature of the exhaust system is very high. Therefore, never attempt to service any part of the exhaust system until it is cooled. Special care should be taken when working near the catalytic converter. The temperature of the converter rises to a high level after a short period of engine operation time.

NOTE: Before replacing a catalytic converter, determine the root cause of failure. Most catalytic converter failures are caused by air, fuel or ignition problems. Refer to the appropriate service diagnostic information for repair procedures.

1. Disconnect oxygen sensor electrical connectors (1 and 2).
2. Loosen intermediate pipe to catalytic converter clamp.

NOTE: Do not use petroleum-based lubricants when removing/installing muffler or exhaust pipe isolators as it may compromise the life of the part. A suitable substitute is a mixture of liquid dish soap and water.

3. Remove muffler/intermediate pipe isolators as necessary to slide muffle/intermediate pipe assembly out of catalytic converter.




4. Disconnect sensor electrical connector.
5. Remove mounting bolts (7) and bracket (6).
6. Remove pre-catalytic converter clamp (4).
7. Remove pre-catalytic converter (5).