Condition - Height Mismatch Between Door Glass and Quarter Glass With Top Down

GLASS ALIGNMENT DIAGNOSIS


CONDITION - HEIGHT MISMATCH BETWEEN DOOR GLASS AND QUARTER GLASS WITH TOP DOWN





1. Verify that the door glass and quarter glass adjustment procedures have been checked.

2. Apply masking tape to outside of glass surface in locations (10), (11), and (12)

3. Close and latch top.

4. With vehicle's engine running, raise quarter glass full up and then raise door glass up then turn engine off.

5. Mark tape at all three locations.

6. Lower top and raise all glass full up.

7. Measure all three tape locations. Location (10), (11), and (12) should be between 5 to 8 mm.

8. Adjust up stop screw (2), if locations (11) and (12) are not within range of 5 to 8 mm.

9. Adjust up stop bracket, (5), if location (10) is not within the range of 5 to 8 mm.

10. With vehicle engine running, lower, all glasses and then raise quarter glasses full up and then raise door glasses full up then turn engine off.

11. Remark and measure, if adjustment is not within range of 5 to 8 mm repeat Steps 8 though 11.

12. If adjustment can not be made, refer to CONDITION - Door Glass Noise Along A-Pillar When Closing Door And/Or Door Glass Touching Quarter Glass Metal Seal Retainer And/Or Wind Noise/Water Leak Along Quarter Glass Seal.