Service Procedure

1. Open the liftgate.

2. Fold rear seatback down and then tumble the seat forward.

3. Remove the right and left side "D" Pillar trim panels.

4. Remove the right and left seatbelt turning loop covers.





5. Remove the right and left seatbelt turning loop bolts (Figure 1).

6. Partially remove both rear door weatherstrips.

7. Remove the "C" pillar covers (Figure 1).

8. Remove the liftgate and both rear door sill plates.

9. Remove the two rear headliner push pins.

10. Remove both rear headliner grab handles.





11. Remove the right and left side lower quarter trim panels (Figure 2).

12. Remove and save the quarter window attaching nuts from both rear quarter windows.

13. Remove and discard the right and left quarter windows from the vehicle by carefully pushing on the quarter glass from inside of the vehicle.





14. Remove any remaining butyl from the quarter window openings on the body (Figure 3).

15. Use 3M General Purpose Adhesive Cleaner (P/N 08987) or equivalent to clean any remaining butyl from the edge of the quarter window openings.

16. Wipe the edge of the quarter window glass openings with isopropyl rubbing alcohol.

17. Remove the butyl tape release paper on each of the new quarter glass assemblies.

18. Place each quarter window glass into position on the vehicle.

19. Install the quarter window glass attaching nuts. Tighten the nuts to 15 in.lbs. (2 N.m). Wait approximately one minute and retighten quarter glass attaching nuts a second time to 15 in. lbs. (2 N.m)

20. Remove the shipping sticker from the new quarter glass windows.

21. Temporarily install both rear door weather strips.

22. Water test quarter windows to verify that there are no water leaks.

23. Partially remove both rear door weather strips and install the right and left side lower quarter trim panels.

24. Install the right and left side "C" pillar trim panels and then install both door weatherstrips.

25. Install the right and left side seatbelt turning loops. Tighten the turning loop bolts to 30 ft.lbs (40 N.m).

26. Install the seatbelt turning loop covers.

27. Install the right and left side "D" pillar covers.

28. Install the liftgate and rear door sill plates.

29. Using Mopar glass cleaner (P/N 04318014AB) or equivalent, thoroughly clean both sides of each new quarter glass window.

30. Close the liftgate.