Assembly

ASSEMBLY




1. Install synchronizer sleeve (1) to gear/hub assembly (3) with GROOVE UP (2).




2. Install three synchronizer strut (1) assemblies.




3. Install needle bearings (1) to reverse shaft.




4. Install reverse blocker ring (1) to shaft assembly (2).




5. Install gear/synchronizer (1) assembly to shaft. Verify that blocker ring (4) is seated into synchronizer hub for proper assembly.




6. Install thrust washer (1).




7. Install bearing (1). Press into place using Installer 6448A (1).




8. Install NEW bearing retaining screw (1).




9. Torque (1) bearing retaining screw (2) to 95 Nm (70 ft. lbs.).