Disassembly

DISASSEMBLY




1. Remove roller bearing retaining screw (2). Use glove or install shaft assembly to soft-jawed vice.




2. Set reverse shaft assembly on arbor press bed supported by bearing splitter P-334. Using Protector 8923 (2).




3. Remove reverse gear (1), thrust washer, and bearing (3) from reverse shaft assembly.




4. Remove synchronizer sleeve (1) and strut assemblies from gear/synchronizer hub (3) assembly.




5. Remove blocker ring (1) from reverse shaft assembly (2).




6. Remove needle bearings (1) from reverse shaft.