Removal

REMOVAL
1. Remove floor mats.

2. Remove front seats.

3. Remove instrument panel lower console.

4. Remove the floor console base tray and disconnect wire connector from the base tray .

5. Remove heel blocker (plastic block below accelerator pedal).

6. Remove winch plug (spare tire winch) (Figure 1).






Figure 1 ACCESS TO WINCH





7. Remove front cowl panels and sill plates.

8. Remove kick plate and heel pad at gas pedal

9. Remove seat belt anchors at the passenger side B-pillar and driver side C-pillars

10. Fold in floor second and third row seats. Refer to the Owner's Manual for the proper procedures.

11. Remove front carpet trim ring and cover (Figure 2).






Figure 2 FRONT TRIM RING AND COVER ASSEMBLY





12. Remove sliding door sill plates.

13. Remove lower B-pillar trim covers.

14. Remove push pin fasteners attaching carpet to floor in front seat area.

15. Roll carpet from under instrument panel to center of sliding door.

16. Pull carpet out from under the quarter trim panel (Figure 3).

17. Using a trim stick, release clips attaching third row carpet cover, and remove (Figure 4).

18. Remove rear carpet screws attaching rear of carpet .

19. Roll and fold carpet forward away from rear door opening.

20. Remove carpet through sliding door opening.






Figure 3 FRONT FLOOR CARPET










Figure 4 ANCHOR MOLDING