Installation

INSTALLATION
1. Insert carpet through sliding door opening.

2. Roll carpet rearward toward rear door opening.

3. Roll carpet under instrument panel.

4. Install push pins fasteners through carpet and grommet into floor to attach carpet to floor in front seat area (Figure 2).

5. Install push pins fasteners in the rear area.


CAUTION: Ensure that the correct fasteners are installed in the proper locations. Damage to the fuel tank may result.

6. Install floor escutcheons (Figure 1).

7. Install the floor console trays.

8. Install Quarter trim panels.

9. Install D-pillar trim covers.

10. Install lower B-pillar trim covers.

11. Install rear door sill plate.

12. Install sliding door sill plates.

13. Install front cowl panels and sill plates.

14. Install the passenger seats. Refer to the Owner's Manual for proper procedures.

15. Install front center console.

16. Install heel blocker (plastic block below accelerator pedal).

17. Install front seats.






Figure 1 SEAT ESCUTCHEONS










Figure 2 FLOOR CARPET