Installation

INSTALLATION
1. Slide the new cable through the retaining bracket. Ensure that the eyelet hook is towards the rear of seat.

2. Continue feeding cable through the retaining bracket until the conduit is through.

3. Feed eyelet through the rear foot. The cable must run underneath the pivot shaft at the base, and feed up through the rear foot. Leave slack in the cable (Figure 1).






Figure 1 FEED EYELET HOOK THROUGH REAR FOOT





4. Attach spring hook to tip of rear foot (Figure 2).






Figure 2 ATTACH SPRING





5. Attach cable to retainer at the base of rear foot (Figure 3).






Figure 3 ATTACH SPRING





6. Attach cable eyelet to spring (Figure 4).






Figure 4 ATTACH EYELET





7. Install cable into retainer at the base of the rear foot (Figure 5).






Figure 5 RETAINER





8. Set cable end clip into position and seat cable end place.

9. Set cable into pulley (Figure 6).






Figure 6 PULLEY

NOTE: Spray white lithium grease (p/n 04318066AB) on the steel pulley, cable and pulley contact each other.

10. Install tie strap (Figure 7).






Figure 7 RETRACTING CABLE
11. Hold the front leg at approximately 45 degree angle and slide the front leg cover onto the leg (Figure 8).






Figure 8 LEG COVER TIP






NOTE: If the front leg cover is not embossed with Do Not Lift as shown (Figure 9), replace all four front leg covers.






Figure 9 DO NOT LIFT EMBOSSMENT
12. Push leg down into the stow position and apply downward force until cover snaps into place.

13. Install seat into vehicle.