Removal

REMOVAL

WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in an accidental airbag deployment and possible severe or fatal injury.





1. Disconnect and isolate the negative battery cable.
2. Remove the defroster grille (2) from the top of the instrument panel Removal.
3. Disconnect the wire harness connector (3) from the sun sensor assembly (1).
4. Remove the screw (4) that secures the sun sensor to the bottom of the defroster grille and remove the sensor.