NV244 GENII Transfer Case

INSTALLATION

1. Mount transfer case on a transmission jack.
2. Secure transfer case to jack with chains.
3. Position transfer case under vehicle.
4. Align transfer case and transmission shafts and install transfer case onto the transmission.
5. Install and tighten transfer case attaching nuts to 27-34 Nm (20-25 ft. lbs.) torque.
6. Connect the vent hose.
7. Connect the shift motor and mode sensor assembly wiring connector. Secure wire harness to clips on transfer case.
8. Align and connect the propeller shafts.Propeller Shaft - Installation Propeller Shaft - Installation
9. Fill transfer case with correct fluid. Transfer Case Fluid Drain and Refill
10. Install skid plate, if equipped.
11. Remove transmission jack and support stand.
12. Lower vehicle and verify transfer case shift operation.