Generator - Removal

2.4L TURBO





The generator is located above the oil filter and axle shaft.

1. Disconnect the negative battery cable.




2. Remove the 2 bolts from the top of the heat shield on the generator.




3. Remove nut from the upper T-bolt adjustment bracket.




4. Raise vehicle and support.
5. Remove the right front wheel.
6. Remove the accessory drive splash shield.
7. Remove the lower heat shield bolt.
8. Remove the generator heat shield.




9. Unplug field circuit connector (1) from generator.
10. Remove the B+ terminal nut (2) and B+ terminal.




11. Remove the pencil strut (2).




12. Loosen the lower generator pivot bolt (1).
13. Loosen the accessory drive belt T-bolt.




14. Remove the generator belt, Accessory Drive Belt - Removal.
15. Remove the axle shaft assembly, Half Shaft - Removal.




16. Remove the generator from the lower mounting bracket and set generator to the side.
17. Remove the lower mounting bracket for the generator.




18. Remove generator through the axle shaft hole.