B2124

B2124-IGNITION RUN CONTROL 1 CIRCUIT OPEN





For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
With the ignition on.

- Set Condition:
(F100) Fused Ignition Switch Output (Run) circuit Open.





Diagnostic Test

1. CHECK FOR ACTIVE DTC
With the scan tool, record and erase DTC's.
Cycle the ignition switch from off to on, leaving the ignition off for a minimum of 30 seconds.
With the scan tool, read the active DTC's.
Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

2. CHECK FOR ACTIVE DTC B2124-IGNITION RUN CONTROL 1 CIRCUIT OPEN WITH THE OCCUPANT RESTRAINT CONTROLLER MODULE DISCONNECTED




WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

Turn the ignition off.
Disconnect the ORC C2 harness connector.
Connect a jumper wire at the 8443 Load Tool from the (F100) Fused Ignition Switch Output (Run) circuit to ground.
Turn the ignition on.
Reconnect the battery.
With the scan tool, read DTCs.
Does the scan tool display active: B2124-IGNITION RUN CONTROL 1 CIRCUIT OPEN?

Yes

- Go to 3

No

- Replace the Occupant Restraint Controller Module.
- Perform BODY VERIFICATION TEST VER-1. Body Verification Test

3. CHECK THE (F100) FUSED IGNITION SWITCH OUTPUT (RUN) CIRCUIT FOR AN OPEN




Turn the ignition off.
Disconnect the TIPM C7 harness connector.
Measure the resistance of the (F100) Fused Ignition Switch Output (RUN) circuit.
Is the resistance above 10K ohms?

Yes

- Repair the (F100) Fused Ignition Switch Output (RUN) circuit for an open.
- Perform BODY VERIFICATION TEST VER-1. Body Verification Test

No

- Replace the TIPM.
- Perform BODY VERIFICATION TEST VER-1. Body Verification Test