Fuel Pump Module - Removal

REMOVAL - GAS





WARNING: Release fuel system pressure before servicing fuel system components. Service vehicles in well ventilated areas and avoid ignition sources. Never smoke while servicing the vehicle. This may result in personal injury or death.

1. Remove fuel filler cap and perform Fuel System Pressure Release procedure, Service and Repair.
2. Remove the air cleaner lid, disconnect the inlet air temperature sensor and makeup air hose.
3. Remove the negative battery cable.
4. Raise vehicle and support.
5. Remove fuel tank, Fuel Tank - Removal.

CAUTION: Clean top of fuel tank around the fuel pump module to remove loose dirt and debris. Failure to clean the fuel tank properly can cause dirt and debris in enter and the fuel system causing damage to the fuel system and/or engine components.

6. Disconnect fuel filter lines from fuel pump module.




CAUTION: Mark the position of the fuel pump module on the top of the fuel tank prior to removal. The pump has to be properly aligned in the tank for the fuel gauge to work properly.

7. Using Special Tool #9340, remove lock ring to release pump module.

WARNING: The fuel reservoir of the fuel pump module does not empty out when the tank is drained. The fuel in the reservoir may spill out when the module is removed. Use caution to avoid personal injury.





8. Remove fuel pump module and seal from tank. Discard seal.