Removal

REMOVAL

WARNING: Do not operate the vehicle within 24 hours of windshield installation. It takes at least 24 hours for urethane adhesive to cure. If it is not cured, the windshield may not perform properly in an accident. Be sure to refer to the urethane manufacturer's directions for curing time specifications, and do not use adhesive after its expiration date.
Caution: open the left front door glass before installing the rear window to avoid pressurizing the passenger compartment if a door is slammed before the urethane bonding is fully cured. Water leaks can result


Refer to the Windshield Removal procedure for a description of tools and adhesive systems that are recommended for use in this procedure.





1. Disconnect and remove CHMSL lamp.

WARNING: Wear eye and hand protection when handling safety glass. Personal injury can result.

CAUTION: Do not damage body or trim finish when cutting out glass or applying fence primer.

2. Remove liftgate trim panels (5).




3. Disconnect wire connectors (2) from rear window defogger.
4. Cut the urethane around the perimeter of the rear window glass (1). Refer to Windshield for proper procedures.
5. Remove the rear window from the vehicle.
6. Prepare the work area, window fence, and glass the same way as described in the Windshield Installation procedure.