Swivel Seat Release

INSTALLATION






NOTE: Illustration shown with riser removed from seat for clarity.

1. Verify the two springs are properly positioned in the seat handle.
2. Carefully engage the two plastic tabs that secure the inside of the handle front cover (2) to the seat release handle (9) and install the front cover to the handle.
3. Install the rear cover (7) onto the seat release handle.
4. Install the two plastic red towers (3) into the front of the seat release handle and install the two screws (1 and 4). Hold the towers in the proper position while tightening the screws securely.
5. Install the two push-pin retainers (6 and 8) that secure the handle front cover to the seat release handle.
6. If required, install the seat riser assembly (5) Seat Riser - Installation.





7. Position the seat cushion front shield (1) to the front of the seat (2) and engage the retaining tabs that secure the shield to the seat.
8. Install the seat into the vehicle.