B10C2

B10C2-REAR DEFROST SWITCH STUCK







- When Monitored:
Continuously.

- Set Condition:
When the Rear Defrost Switch in the Switch Bank is held in the On position for over 10 seconds, this code will set.





1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase DTC's.
3. Operate the Rear Defrost Switch several times.
4. Cycle the ignition from on to off.
5. Turn the ignition on.
6. With the scan tool, read DTC's.

Does the scan tool display B10C2-REAR DEFROST SWITCH STUCK?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST. Body Verification Test.

2. SWITCH SHORTED




1. With the scan tool, erase DTC's.
2. Disconnect the Switch Bank connector.
3. With the scan tool, read DTC's.

Does the scan tool display B10C2-REAR DEFROST SWITCH STUCK?

No

- Replace the Switch Bank.
- Perform BODY VERIFICATION TEST. Body Verification Test.

Yes

- Go To 3

3. (D506) LIN BUS CIRCUIT PARTIAL SHORT TO GROUND




1. Turn the ignition off.
2. Disconnect the Cluster C3 connector.
3. Measure the resistance between ground and the (D506) LIN Bus circuit.

Is the resistance below 10000.0 ohms?

Yes

- Repair the (D506) LIN Bus circuit for a partial short to ground.
- Perform BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Instrument Cluster.
- Perform BODY VERIFICATION TEST. Body Verification Test.