P1275

P1275-A/C CLUTCH CONTROL CIRCUIT 2 OVERCURRENT







- When Monitored:
With the ignition on. Battery voltage greater than 10.4 volts. TIPM requesting A/C Clutch operation.

- Set Condition:
An overcurrent condition is detected in the A/C Clutch control output circuit. One Trip Fault. Three good trips to turn off the MIL.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.

1. A/C CLUTCH OPERATION
1. Ignition on, engine not running.
2. With a scan tool in the TIPM Actuators, actuate the A/C Clutch.

Is the A/C Clutch operating?

Yes

- Perform the INTERMITTENT CONDITION diagnostic procedure. Intermittent Condition Test.

No

- Go To 2

2. VISUAL AND PHYSICAL CONNECTOR AND TERMINAL INSPECTION
1. Turn the ignition off.
2. Disconnect the TIPM C10 harness connector.
3. Disconnect the A/C Clutch harness connector.
4. Inspect the terminal and connector condition. Check for signs of corrosion build up or damage the would compromise the terminal to controller pin connector.

NOTE: Make sure that all in-line connectors are inspected for corrosion and/or damage.

5. Visually inspect the wiring harness. Look for any chafed, pierced, pinched or partially broken wires hidden in the wire insulation.

Were any of the above conditions found?

Yes

- Repair or replace as necessary.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.

No

- Go To 3

3. (C3) A/C CLUTCH CONTROL OUTPUT CIRCUIT HIGH RESISTANCE




1. With a jumper wire, connect one end to the (C3) A/C Clutch Control Output circuit in the A/C Clutch harness connector and the other to a clean chassis ground.
2. Using a 12-volt test light to battery voltage, probe the (C3) A/C Clutch Control Output circuit in the TIPM C10 harness connector.

NOTE: The test light should be illuminated and bright. Compared the brightness to that of a direct connection to the battery.

Does the test light illuminate brightly.

Yes

- Go To 4

No

- Repair the high resistance in the (C3) A/C Clutch Control Output circuit.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.

4. (Z902) A/C CLUTCH GROUND CIRCUIT




1. Using a 12-volt test light to battery voltage, probe the (Z902) A/C Clutch Ground circuit in the A/C Clutch harness connector.

NOTE: The test light should be illuminated and bright. Compared the brightness to that of a direct connection to the battery.

Does the test light illuminate brightly.

Yes

- Go To 5

No

- Repair the excessive resistance in the (Z902) A/C Clutch Ground circuit.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.

5. A/C CLUTCH CONTROL OUTPUT FROM TIPM
1. Reconnect the TIPM C10 harness connector.
2. Ignition on, engine not running.
3. With a scan tool in the TIPM Actuators, actuate the A/C Clutch.
4. Using the 12-volt test light connected to ground, probe the (C3) A/C Clutch Control Output circuit in the A/C Clutch harness connector.

Does the test light illuminate brightly?

Yes

- Replace the A/C Clutch.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.

No

- Replace the Totally Integrated Power Module (TIPM).
- Perform the BODY VERIFICATION TEST. Body Verification Test.