Valve Body - Installation

INSTALLATION










NOTE: If valve body assembly is being replaced or reconditioned, it is necessary to perform the PCM Quick Learn Procedure Testing and Inspection .

1. Install accumulators and springs as previously removed. Install valve body assembly to transaxle.










2. Install and torque valve body-to-transaxle case bolts to 12 Nm (105 in. lbs.).










3. Install transaxle oil filter. Inspect the o-ring and replace if necessary.










4. Ensure the transaxle oil pan and transaxle case sealing surfaces are clean and dry. Install an 1/8" bead of MOPAR(R) Silicone Rubber Adhesive Sealant to the oil pan and install.









5. Torque oil pan-to-transaxle case bolts to 19 Nm (165 in. lbs.).
6. Raise engine cradle crossmember into position.
7. Aligning index/scribe mark placed upon disassembly, Install four cradle-to-body bolts and torque to 162 Nm (120 ft. lbs.).
8. Lower vehicle.
9. Remove engine support fixture 8534B.
10. Raise vehicle.
11. Install and torque engine front and rear mount-to-cradle nuts to 54 Nm (40 ft. lbs.).
12. Lower vehicle.
13. Connect transmission range sensor connector.
14. Install manual valve lever to manual shaft.
15. Install gearshift cable to manual valve lever.
16. Install battery and tray.
17. Connect battery negative cable.
18. Fill transaxle with Mopar(R) ATF +4 Transmission fluid. Fluid/Filter Service