Antenna Mast - Installation

INSTALLATION





1. Install the antenna body and cable assembly to the fender.
2. Insert antenna cable through the opening in the fender.
3. Seat the grommet in the side panel and connect the cable to the instrument panel harness connector.
4. Install the antenna nut and adapter.
5. Install the shroud (if equipped).
6. Install the inner fender shield. Splash Shield - Installation.
7. Install the antenna mast. Tighten to 5 N-m (46 in. lbs.). Ensure that the antenna mast is fully seated on the antenna base and that there is no gap between the mast and the base.
8. Connect the antenna cable to the instrument panel antenna cable.
9. Install the right side cowl trip panel. Cowl Trim Panel - Installation.
10. Connect the battery negative cable.