First Row

INSTALLATION

NOTE: Left seat shown in illustrations. Right seat similar.





1. Position the seat cushion cover (2) to the seat cushion (5) and engage the retaining strips (1) to the clips (3).





2. Install the seat back cover (2) and the seat back cushion (3) onto the seat back frame (5) as an assembly.
3. Engage the seat back cover to the two metal tabs (4) located near the bottom of the seat back frame.
4. Engage the five J-hook retainers (1) that secure the top and sides of the seat back cover to the seat back frame.





5. If equipped with lumbar support, locate the area where the lumbar handle shaft (2) resides on the outboard side of the seat back assy (1). The lumbar handle shaft (2) will protrude out slightly after the seat cover is installed.





6. Using a suitable tool, carefully cut around the perimeter (2) of the lumbar handle shaft (3) to expose the shaft.
7. Install the lumbar support handle Seat Handle - Installation.
8. Install the headrest sleeves Headrest Sleeve - Installation.
9. Install the headrest Headrest - Installation.
10. Install the armrest Armrest - Installation.
11. Install the seat back panel Seat Back Panel - Installation.
12. Install the seat back onto the seat Seat Back - Installation.
13. Install the seat into the vehicle Seat - Installation.