First Row

REMOVAL

WARNING: Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: Left seat shown in illustrations. Right seat similar.





1. Remove the seat from the vehicle and place it on a workbench Seat - Removal.
2. Remove the seat back from the seat Seat Back - Removal.
3. Remove the seat back panel Seat Back Panel - Removal.
4. Remove the armrest Armrest - Removal.
5. Remove the headrest Headrest - Removal.
6. Remove the headrest sleeves Headrest Sleeve - Removal.
7. Disengage the five J-hook retainers (1) that secure the top and sides of the seat back cover (2) to the seat back frame (5).
8. Disengage the seat back cover from the two metal tabs (4) located near the bottom of the seat back frame.
9. Remove the seat back cover and the seat back cushion (3) from the seat back frame as an assembly.





10. Using a hooked tool (4), disengage the retaining strips (1) from the clips (3) that secure the seat back cushion cover (2) to the seat back cushion (5) and remove the cover.