Leg Retractor Spring - Installation

INSTALLATION

1. Attach the new spring to the cable.




2. Attach the spring (1) at the bracket (3). The seat must remain at the 20-45° angle (2) and the leg on the outboard side of the seat must be held down to keep slack in the cable

CAUTION: Do not use pliers to attach the spring to the bracket. Damage to the spring may occur. There should be enough slack in the cable to attach the spring using your hands.

3. Fold the seat down into the floor.
4. Remove both trim sticks from the legs.
5. Install the floor carpet cover.
6. Install the retracting leg shields. Leg Retractor Spring - Installation