Dynamics Sensor - Installation

INSTALLATION






NOTE: When installed, arrow on dynamics sensor housing must point towards front of vehicle.

1. Position the dynamics sensor (2) on the mounting bracket (4) with the arrow pointing to the front of the vehicle and the connector facing the passenger side of the vehicle.
2. Install the two mounting screws (1). Tighten the screws to 9 Nm (80 in. lbs.).
3. Connect the wiring harness connector (3) to the dynamics sensor (1).





4. Install the right intermediate floor distribution duct (2).





5. Install the instrument panel center support brackets (3) and mounting screws (2). There is one bracket on each side of the tunnel structure.
6. Reinstall the carpet onto the front floor pan and under the instrument panel Carpet - Installation.





7. Install the instrument panel center stack console. Instrument Panel Bin - Installation
8. Connect the battery negative cable to the battery post.
9. Perform the Diagnostic Verification Test and clear any faults. Service and Repair