Driver Door Module (DDM)

B210E-BATTERY VOLTAGE HIGH







- When Monitored:
At all times.

- Set Condition:
The module senses voltage input above 15.9 volts for over 15 seconds.





1. CHECK ENGINE DTCs
1. With the scan tool, read ENGINE DTCs.

Are there any ENGINE Charging or Battery DTCs present?

No

- Go to 2

Yes

- Perform the appropriate diagnostic procedure. Testing and Inspection.

2. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, erase all DTCs.
2. Start the engine and run for 2 minutes.
3. With the scan tool, read the DTCs.

Does the scan tool display active: B210E-BATTERY VOLTAGE HIGH?

Yes

- Replace the Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.