Front Seat Cushion Frame - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: Power heated seat shown. Manual and non-heated seat similar.





1. Remove the seat from the vehicle and place it on a workbench Seat - Removal.
2. Remove the seat back Seat Back - Removal.
3. Remove the seat cushion cover (2), seat cushion (5) and the wire harness (4) (if equipped) from the seat cushion frame (3) Seat Cushion Cover - Removal.
4. If equipped, remove the four power seat track isolators (1) from the bottom of the seat cushion frame.