P0750

P0750 - LR SOLENOID CIRCUIT

When Monitored and Set Condition:
P0750 - LR SOLENOID CIRCUIT

When Monitored: Initially at power-up, then every 10 seconds thereafter. The solenoids will also be tested immediately after a gear ratio or pressure switch error is detected.

Set Condition: Three consecutive solenoid continuity test failures, or one failure if test is run in response to a gear ratio or pressure switch error.

POSSIBLE CAUSES:
RELATED RELAY DTC'S PRESENT
INTERMITTENT WIRING AND CONNECTORS
TRANSMISSION RELAY OUTPUT CIRCUIT OPEN
LR SOLENOID CONTROL CIRCUIT OPEN
LR SOLENOID CONTROL CIRCUIT SHORT TO GROUND
LR SOLENOID CONTROL CIRCUIT SHORT TO VOLTAGE
LR SOLENOID/PRESSURE SWITCH ASSEMBLY
TCM - LR SOLENOID CIRCUIT