Sunroof / Moonroof: Testing and Inspection
DIAGNOSIS AND TESTINGSunroof Diagnosis Chart:
Before beginning sunroof diagnostics verify that all other power accessories are in proper operating condition. Refer to Sunroof Diagnostic Chart for possible causes. If not, a common electrical problem may exist. Check the condition of the circuit protection (20 amp high current fuse (battery feed) located in the Power Distribution Center (PDC). Check the cover of the PDC for location of the fuse. The ten amp fuse (ignition feed) located in cavity 14 of the Junction Block). Inspect all wiring connector pins for proper engagement and continuity. Check for battery voltage at battery and ignition pins of the power sunroof express module wiring connector. The controller will not operate at less than 10 volts. Check the ground at the sunroof express module.
Before beginning diagnosis for wind noise or water leaks, verify that the problem was not caused by releasing the control switch before the was sunroof fully closed. The sunroof module has a water-management system. During washing high-pressure water may be forced between the glass panel seal and the roof opening. Normally this water will drain. However, when some type of drying blower system is used, like those found in automatic car washes, the water may not have a chance to drain before the blower forces air between the seal and the roof opening. This causes the water to blow over the edge of the module and onto the headlining.
Fig. 1 Sunroof Assembly:
Refer to Sunroof Assembly exploded view of the sunroof.