Headrest Sleeve - Airbag Equipped

HEADREST SLEEVE - AIRBAG EQUIPPED

REMOVAL - AIRBAG EQUIPPED

WARNING:
- DISCONNECT AND ISOLATE THE NEGATIVE BATTERY CABLE REMOTE TERMINAL BEFORE BEGINNING ANY FRONT SEAT REMOVAL OR INSTALLATION PROCEDURE. THIS WILL DISABLE THE AIRBAG SYSTEM. FAILURE TO DISCONNECT THE BATTERY COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
- ONCE THE NEGATIVE CABLE IS DISCONNECTED WAIT FOR 2 MINUTES BEFORE REMOVING ANY AIRBAG SYSTEM COMPONENTS.

1. Disconnect the remote negative battery cable.
2. Remove the head restraint from the seat back.
3. Remove the back panel from the seat back.

Fig. 5:

4. Disengage upper J-strap from seat back trim cover. (Fig. 5)
5. Working through the rear of seat back, depress the two head restraint guide sleeve retaining tabs and pull guide straight up and out of the seat back.

INSTALLATION - AIRBAG EQUIPPED

NOTE: The head restraint guide sleeve equipped with height adjustment button is always installed on the left side of the seat back.

1. Install guides in seat back making sure they are snapped in place.
2. Install J-strap retainer.
3. Install the back panel on the seat back.
4. Install the head restraint on the seat back.
5. Connect the remote negative battery cable.