Seat Adjusters

SEAT ADJUSTERS

REMOVAL - AIRBAG EQUIPPED

WARNING:
- DISCONNECT AND ISOLATE THE NEGATIVE BATTERY CABLE REMOTE TERMINAL BEFORE BEGINNING ANY FRONT SEAT REMOVAL OR INSTALLATION PROCEDURE. THIS WILL DISABLE THE AIRBAG SYSTEM. FAILURE TO DISCONNECT THE BATTERY COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
- ONCE THE NEGATIVE CABLE IS DISCONNECTED WAIT FOR 2 MINUTES BEFORE REMOVING ANY AIRBAG SYSTEM COMPONENTS.

1. Disconnect and isolate the remote negative battery cable.
2. Remove the front seat back. Refer to the procedure in this group.

Fig. 44:

3. Remove bolts attaching seat adjuster to cushion pan (Fig. 44).
4. Disconnect wire harness from cushion pan.
5. Remove seat adjuster from seat cushion.

INSTALLATION - AIRBAG EQUIPPED

1. Place seat adjuster in position on seat cushion pan.
2. Connect wire harness to the cushion pan.
3. Install bolts attaching seat adjuster to cushion pad.
4. Install seat back. Refer to the procedure in this group.
5. Install bolt to attach seat back recliner to seat back on each side of seat. Tighten bolt to 8 N.m (71 in.lbs.) torque.
6. Connect the negative battery cable.
7. Using the DRB III(R) Scan Tool erase all DTC's and perform airbag system diagnostics.