Rear Seat Back

REAR SEAT BACK

REMOVAL

1. Remove rear seat cushion.

Fig. 35:

2. Remove inboard nuts attaching rear seat back and belts to floor and outboard bolts attaching seat back to floor (Fig. 35).
3. Pull bottom of seat back out to slide rear seat back mounts off studs. Push rear seat back upward to disengage hooks at top of seat back.
4. Remove rear seat back from vehicle.

REMOVAL - 40 SECTION

Fig. 36:

1. Remove seat back collar assembly (Fig. 36).

Fig. 37:

2. Remove bolt attaching 40 section (Fig. 37).

Fig. 38:

3. Slide seat back 40 section off pin and remove from the collar assembly (Fig. 38).

REMOVAL - 60 SECTION

1. Remove seat back collar assembly.
2. Remove bolt attaching 40 seat section.
3. Remove the 40 seat section.

Fig. 39:

4. Remove bolt attaching 60 seat section (Fig. 39).
5. Slide seat back 60 seat section off pivot bracket and remove from the collar assembly.

REMOVAL - 60/40 SEAT COLLAR ASSEMBLY

1. Remove rear seat cushion.
2. Remove nuts attaching rear seat back collar assembly.
3. Remove rear seat back collar assembly.
4. Remove the 40 seat section from the rear seat back collar assembly.

Fig. 40:

5. Remove the 60 seat section from the rear seat back collar assembly (Fig. 40).

INSTALLATION

1. Place rear seat back in position in vehicle.
2. Engage hooks at top of seat back.
3. Install inboard nuts and outboard bolts attaching rear seat back and belts to floor. Tighten to 40 N.m (29 ft.lbs.) torque.
4. Install rear seat cushion.

INSTALLATION - 40 SECTION

1. Place seat back 40 section on pin.
2. Install bolt attaching 40 section seat back to collar section. Tighten bolt to 16 N.m (12 ft.lbs.) torque.
3. Install seat back collar assembly.

INSTALLATION - 60 SECTION

1. Install the 60 seat section on pivot bracket.
2. Install bolt attaching 60 seat section. Tighten bolt to 16 N.m (12 ft.lbs.) torque.
3. Install the 40 seat section on pin.
4. Install bolt attaching 40 seat section. Tighten bolt to 16 N.m (12 ft.lbs.) torque.
5. Install seat back collar assembly.

INSTALLATION - 60/40 SEAT COLLAR ASSEMBLY

1. Install the 60 seat section from the rear seat back collar assembly.
2. Install the 40 seat section from the rear seat back collar assembly.
3. Place the rear seat back collar assembly in position in vehicle.
4. Install nuts and bolts attaching rear seat back collar assembly. Tighten nuts and bolts to 40 N.m (29 ft.lbs.) torque.
5. Install the rear seat cushion.