Seat Track & Recliner Assembly

SEAT TRACK & RECLINER ASSEMBLY

REMOVAL

WARNING:
- DISCONNECT AND ISOLATE THE NEGATIVE BATTERY CABLE REMOTE TERMINAL BEFORE BEGINNING ANY FRONT SEAT REMOVAL OR INSTALLATION PROCEDURE. THIS WILL DISABLE THE AIRBAG SYSTEM. FAILURE TO DISCONNECT THE BATTERY COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
- ONCE THE NEGATIVE CABLE IS DISCONNECTED WAIT FOR 2 MINUTES BEFORE REMOVING ANY AIRBAG SYSTEM COMPONENTS.

1. Remove seat cushion side shield.

Fig. 28:

2. Remove bolts attaching seat back recliner to seat back frame on each side of seat (Fig. 28).

Fig. 29:

3. Remove bolts attaching seat adjuster to cushion pan (Fig. 29).
4. Disconnect wire harness fasteners from cushion pan.
5. Remove seat adjuster from seat cushion.

INSTALLATION

1. Place seat adjuster in position on seat cushion pan.
2. Connect wire harness fasteners to the cushion pan.
3. Install bolts attaching seat adjuster to cushion pad.
4. Install seat back.
5. Install bolt attaching seat back recliner to seat back on each side of seat. Tighten bolt to 8 N.m (71 in.lbs.) torque.
6. Install the seat cushion side shields.