Horn Switch: Service and Repair

REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO ELECTRICAL, RESTRAINTS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

The Horn Switch is an intregal part of the Driver Airbag Module and if defective, the Driver Airbag Module must replaced.

Negative Battery Cable Remote Terminal:

1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove the two speed control switch screws from the steering wheel back cover.
3. Remove the two speed control switches and disconnect the wires.
4. Remove the two bolts retaining the Driver Airbag Module.
5. Lift the module and disconnect the airbag horn wire connectors.
6. Remove the Driver Airbag Module from the vehicle.

INSTALLATION
1. Connect the airbag horn wire connectors.
2. Install the two bolts retaining the Driver Airbag Module.
3. Install the two speed control switches and connect the wires.
4. Install the two speed control switch screws to the steering wheel back cover.
5. Reconnect the battery negative cable remote battery post.