Rear Seat Cushion Cover

REAR SEAT CUSHION COVER

REMOVAL - REAR SEAT CUSHION COVER

1. Remove rear seat cushion.

Fig. 29:

2. Disengage the J-strap retainers (Fig. 29).

Fig. 30:

3. Cut hog rings to free cover (Fig. 30).
4. Remove seat cushion cover from seat cushion.

REMOVAL - JR-27 (Convertible) ONLY

1. Remove rear seat cushion from vehicle.
2. Place seat cushion on a suitable work surface in inverted position.
3. Remove hog rings around perimeter of seat cushion attaching seat cushion cover to seat cushion frame.
4. Pull seat cover from seat cushion frame and seat cushion foam.
5. Remove hog rings attaching seat cover seam wires to seat foam wires.
6. Remove seat cover from seat frame and seat cushion foam.

INSTALLATION - REAR SEAT CUSHION COVER

1. Position seat cushion cover on cushion.
2. Install hog rings to seat cover.
3. Engage the J-strap retainers.
4. Steam wrinkles from seat cushion, if necessary.
5. Install seat cushion.

INSTALLATION - JR-27 (Convertible) ONLY

1. Position seat cushion cover to seat cushion frame and seat cushion foam.
2. Install a hog ring at each hog ring location to attach seat cushion cover seam wires to wires in seat cushion foam. Begin at center location and work outward.
3. Repeat above steps for opposite inboard vertical seam, both outboard vertical seams, and for the horizontal seams.
4. Pull seat cover over seat cushion frame and seat cushion foam.
5. Install hog rings at hog ring locators around perimeter of seat cushion foam attaching seat cushion cover to seat cushion frame.
6. Install rear seat cushion to vehicle.