Adhesive Components

INSTALLATION AND REMOVAL OF ADHESIVE COMPONENTS






REMOVAL




1. Attach protection tape all the way along the edges of the double-sided tape which is still adhering to the body.




2. Use a resin spatula to scrape off the double-sided tape.
3. Peel off the protection tape.
4. Wipe the body surface and clean it with a rag moistened with isopropyl alcohol.

INSTALLATION




1. Scrape oft the double-sided tape with a resin spatula or gasket scraper.
2. Use a shop towel moistened with 3M(TM) AAD Part number 8906 or equivalent to wipe the protect moulding surface.

CAUTION: Do not remove all of the residual adhesive.

3. Remove only a small portion of the residual adhesive.

CAUTION:
- Always apply it evenly on the entire surface, because a lot or little will reduce its strength.
- Do not touch the painted surface.

4. Soak a sponge in the 3M(TM) AAD Part number 8608 Super Fast Urethane Primer or equivalent, and apply evenly to the protect moulding.
5. After applying the primer, let it dry for 3 to 30 minutes.
6. Affix the specified double-sided tape to the protect moulding.