Rear Seat Back

REAR SEAT BACK

REMOVAL - FOLDING BACK

NOTE: Fabric covered cushions are serviced as an assembly.

1. Remove rear seat cushion.
2. Remove the rear seat buckles and belt anchors.

Fig. 31:

3. Remove the outer seat back bracket nuts (Fig. 31).
4. Release folding rear seat back latches.
5. Remove seat back from vehicle.

REMOVAL - JR-27 (Convertible) ONLY

1. Remove rear seat cushion.

Fig. 32:

2. Pull bottom of rear seat back forward until seat back brackets clear studs on floor pan (Fig. 32).
3. Push upward on rear seat back and disengage hooks attaching seat back to rear seat back support.
4. Remove rear seat back from vehicle.

INSTALLATION - FOLDING BACK

NOTE: Fabric covered cushions are serviced as an assembly.

1. Place the four seat back brackets over the body mounted weld studs and position seat back in vehicle.
2. Engage folding rear seat back latch.
3. Install the outer seat back bracket nuts and tighten to 61 Nm (45 ft.lbs.).
4. Install the rear seat buckles and belt anchors.
5. Install rear seat cushion.

INSTALLATION - JR-27 (Convertible) ONLY

1. Position rear seat back in vehicle.
2. Tilt rear seat back rearward and raise seat back above retaining brackets on rear seat back support.
3. Lower rear seat back until center loop begins to engage.
4. Lower rear seat back and push rearward on outboard corners of seat back to engage outboard hooks to brackets on rear seat back support.
5. Push downward on rear seat back until all hooks are fully engaged into retaining brackets.
6. Install rear seat cushion.