Rear Seat Back Cover

REAR SEAT BACK COVER

REMOVAL - JR-27 (Convertible) ONLY

1. Remove rear seat back from vehicle.
2. Place seat back on a suitable work surface in inverted position.
3. Remove hog rings around perimeter of seat back holding seat back cover to seat back frame.
4. Pull seat cover from seat back frame and seat back foam.
5. Remove any hog rings holding seat cover seam wires to seat foam wires.
6. Remove seat cover from seat frame and seat back foam.

INSTALLATION - JR-27 (Convertible) ONLY

1. Position seat cover to seat back frame and seat back foam.
2. Align notch in center of seat back cover vertical seam to center hog ring locator.
3. Install a hog ring at each hog ring location, center first, attaching seat back cover seam to wires in seat back foam.
4. Repeat the above steps for the opposite inboard vertical seam, both outboard vertical seams, and the lower horizontal seam.
5. Install hog rings at each hog ring locator, center first, to attach ends of vertical portions of U-shaped wires to vertical foam wires.
6. Align notch in center of upper horizontal seat cover seam to center hog ring location.
7. Install a hog ring at each hog ring locator to hold upper horizontal seam wire to wire in seat back foam.
8. Install hog rings attaching seat cover seam wires to seat frame.
9. Pull seat cover over seat back frame and seat back foam.
10. Install hog rings at hog ring locators around perimeter of seat back cushion attaching seat cover to seat back frame.
11. Install rear seat back to vehicle.