Cruise Control Switch: Service and Repair

REMOVAL
The speed control switches are mounted in the steering wheel and wired through the clock spring device under the airbag module.

WARNING: IF REMOVAL OF AIRBAG MODULE IS NECESSARY, REFER TO the RESTRAINT SYSTEMS for more information.

1. Remove the negative battery cable.
2. Turn OFF ignition.

Fig.4 Speed Control Switch:

3. Remove screw from back of the switch.
4. Rock switch away from airbag and steering wheel.
5. Disconnect two-way electrical connector.
6. Repeat for the other switch.

INSTALLATION
1. Connect two-way electrical connector.
2. Install switch.
3. Install screw into the back of the switch.
4. Repeat for the other switch.
5. Install the negative battery cable.