Master Cylinder Bleeding

STANDARD PROCEDURE - MASTER CYLINDER BLEEDING
1. Clamp the master cylinder in a vise using only the mounting flange.
2. Thread Bleeding Tubes, Special Tool 8358, into master cylinder primary and secondary ports. Position outlet ends of bleeding tubes in reservoir with the outlets below surface of brake fluid when reservoir is filled to its proper level.
3. Fill brake fluid reservoir with Mopar(R) brake fluid or equivalent conforming to DOT 3 specifications.
4. Using a wooden dowel, depress push rod slowly, and then allow pistons to return to released position. Repeat several times until all air bubbles are expelled from master cylinder.
5. Remove bleeding tubes from master cylinder outlet ports, and then plug outlet ports and install fill cap on reservoir.
6. Remove master cylinder from vise.
7. Install the filler cap on master cylinder fluid reservoir.
8. Install master cylinder.