Recliner Motor

REMOVAL
1. Disconnect the negative battery cable.




2. Remove the seat back cover enough to expose the recliner motor.
3. Remove the bolt (1) attaching the recliner motor to the seat back frame and disconnect the recliner motor harness connector (2).




4. Remove the snap ring on the shaft then remove the shaft (2) from the seat back frame (1).
5. Remove the recliner motor.

INSTALLATION




NOTE: Ensure the rubber mount for the attachment bolt is seated properly.

1. Install the shaft (2) to the seat back frame (1) and install the snap ring.

NOTE: Ensure the harness is routed and secured in its original position to avoid potential interference with moving parts.




2. Position the recliner motor to the seat back frame and install the attachment bolt (1). Connect the recliner motor harness connector (2).
3. Install the seat back cover.
4. Connect the negative battery cable.