A/C Heater Control

WARING: ON VEHICLES EQUIPPED WITH AIR-BAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel from the instrument panel.

Heater - A/c Control:

3. Remove the three screws that secure the heater-A/C control to the instrument panel.

4. Remove the heater-A/C control from the instrument panel and disconnect the two wire harness connectors from the control.

INSTALLATION
1. Connect the two wire harness connectors to the heater-A/C control.
2. Position the heater-A/C control into the instrument panel.
3. Install and tighten the three screws that secure the heater-A/C control to the instrument panel. Tighten the screws to 2 Nm (17 in. lbs.).
4. Reconnect the battery negative cable.