Installation

INSTALLATION

FRONT SEAT - RIGHT SIDE

1. Before proceeding with the following repair procedure, review all warnings and cautions.


WARNING: The front passenger seat must be handled carefully as well. When removing the seat, be careful when setting on floor not to drop. If dropped, the sensor may be inoperative. Failure to follow these instructions may result in personal injury or death.


WARNING: When the seat is on the floor, no one should sit in the front passenger seat. This uneven force may damage the sensing ability of the seat weight sensors. If sat on and damaged, the sensor may be inoperative. Failure to follow these instructions may result in personal injury or death.





2. With battery negative cable disconnected.

3. Place seat into position in vehicle.


WARNING: The front passenger seat must be handled carefully as well. When removing the seat, be careful when setting on floor not to drop. If dropped, the sensor may be inoperative. Failure to follow these instructions may result in personal injury or death.

4. Connect the electrical connectors.

5. Place the ignition key in the run position.

6. Connect battery negative cable.

7. Place ignition key in the off position.

8. Move the seat forward to gain access to the rear bolts, as necessary.

9. Install the front seat attaching rear bolts (1) and (2).





10. Install the front seat front attaching bolts (1).

11. The supplemental restraint system verification test procedure should be performed following service of any supplemental restraint system component.

12. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System Verification Test using a scan tool.

FRONT SEAT - LEFT SIDE





1. Place seat into position in vehicle.

2. Connect the electrical connectors.

3. Connect battery negative cable.

4. Move the seat forward to gain access to the rear bolts.

5. Install the front seat attaching rear bolts (1) and (2).





6. Install the front seat front attaching bolts (1).





7. Install the cover (1) and lower seat belt anchor bolt (2).