Removal

REMOVAL




1. Before proceeding with the following repair procedure, review all warnings and cautions.

2. Remove the cover (1) and lower seat belt anchor bolt (2).


FRONT SEAT - LEFT SIDE





1. Remove the left side front seat two front attaching bolts (1).





2. Move the seat forward to gain access to the rear bolts.

3. Remove the left side front seat two rear attaching bolts (1) and (2).

4. Disconnect and isolate battery negative cable.

5. Disconnect the electrical connectors.

6. Remove the seat.


FRONT SEAT - RIGHT SIDE

1. Before proceeding with the following repair procedure, review all warnings and cautions.


WARNING: The front passenger seat must be handled carefully as well. When removing the seat, be careful when setting on floor not to drop. If dropped, the sensor may be inoperative. Failure to follow these instructions may result in personal injury or death.


WARNING: When the seat is on the floor, no one should sit in the front passenger seat. This uneven force may damage the sensing ability of the seat weight sensors. If sat on and damaged, the sensor may be inoperative. Failure to follow these instructions may result in personal injury or death.





2. Remove the right side front seat with OCS sensor two front attaching bolts (1).





3. Move the seat forward to gain access to the rear bolts.

4. Remove the right side front seat with OCS sensor two rear attaching bolts (2) and (3).

5. Ensure that the ignition key is in the off position.

6. Disconnect and isolate battery negative cable.

7. Disconnect the electrical connectors.

8. Remove the seat.