Installation

INSTALLATION





1. Support fuel tank with transmission jack.





2. Raise tank and push filler tube vent line through bracket.





3. Fuel tank strap bolt locations.





4. Install bolt for fuel tank strap and tighten.





5. Install bolt for fuel tank strap and tighten.





6. Connect vapor line.





7. Connect the fuel supply line.





8. Connect the EVAP line in the right rear wheel well.

9. Install the drive shaft.

10. Install the exhaust system.





11. Install metal filler tube to rubber tube on fuel tank.





12. Install clamp to filler tube and tighten





13. Connect the filler tube vent line.





14. Install the inner splash shield.





15. Install the left underbody splash shield.





16. Install the right underbody splash shield.

17. Install left rear tire.

18. Lower vehicle.





19. Install module and align marks on the module for proper orientation.





20. Install module lock-ring.

21. Use special tool #9340 to tighten left side module lock ring.

22. Connect the electrical connector to left side module and install plastic access cover.





23. Install module and align marks on the module for proper orientation.





24. Install module lock-ring.

25. Use special tool #9340 to tighten right side module lock ring.

26. Connect the fuel supply line to module.





27. Install plastic access covers to floor pan right side.





28. Fold the foam pad covering access cover for modules back into place.





29. Install rear lower seat cushion





30. Rear lower seat cushion installed.





31. Fill fuel tank.

32. Connect negative battery cable.

33. Fill fuel tank. Use the scan tool to pressurize the fuel system. Check for leaks.