Right Side Module

RIGHT SIDE MODULE




1. Install level sending card, make sure that the locking tabs are locked on the card.





2. Route wires in the proper location.

3. Tie strap the wires harness to the hoses.





4. Feed hoses and wiring harness into fuel tank and over the center hump in tank.





5. Install module and align marks on the module for proper orientation.





6. Install module lock-ring.

7. Use special tool #9340 to tighten right side module lock ring.

8. Connect the fuel supply line to module.





9. Install plastic access covers to floor pan right side.





10. Install the fuel return hoses to module.

11. Install fuel supply line to module.





12. Make sure that wires are routed properly.





13. Make sure that the level sending card wire is tie strapped to the fuel supply line at the module.





14. Install left side module top to module bottom.





15. Connect the electrical connectors for right side fuel level sending card, left side module card. Make sure that wires are routed properly.





16. Install module and align marks on the module for proper orientation.





17. Install module lock-ring.

18. Use special tool #9340 to tighten left side module lock ring.

19. Connect the electrical connector to left side module and install plastic access cover.





20. Fold the foam pad covering access cover for modules back into place.





21. Install rear lower seat cushion





22. Rear lower seat cushion installed.





23. Fill fuel tank.

24. Connect negative battery cable.

25. Fill fuel tank. Use the scan tool to pressurize the fuel system. Check for leaks.