RWD

RWD





NOTE: Prior to installation, inspect magnetic encoder (for wheel speed sensor) (2) for any damage and make sure any metal debris sticking to it is removed.

1. Slide hub and bearing onto knuckle spindle.




2. Install hub nut (1) on end of spindle. Tighten hub nut to 250 Nm (184 ft. lbs.) torque.
3. Install brake rotor, then disc brake caliper and adapter assembly.

NOTE: Install a new dust cap to preserve seal integrity.

4. Install NEW dust cap (2) on hub and bearing.




5. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque.
6. Lower vehicle.




7. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
8. Check and adjust brake fluid level in reservoir (1) as necessary.
9. Road test vehicle and make several stops to wear off any foreign material on brakes and to seat brake pads.