B10FD
B10FD - AIRBAG WARNING INDICATOR CIRCUIT SHORT TO BATTERY
- When Monitored: With the ignition on. The Occupant Restraint Controller (ORC) monitors the status of the Airbag Warning Indicator Driver circuit.
- Set Condition: The DTC will set if the Airbag Warning Indicator Driver circuit is shorted to voltage.
Diagnostic Test
1. MEASURE AIRBAG WARNING INDICATOR DRIVER CIRCUIT VOLTAGE
With the ignition off.
Disconnect the Instrument Cluster harness connector.
NOTE: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Airbag Warning Indicator Driver circuit at the Instrument Cluster harness connector.
Is the voltage above 11 volts?
Yes
- Repair the Airbag Warning Indicator Driver circuit for a short to voltage.
- Perform AIRBAG VERIFICATION TEST. Airbag System Verification Test
No
- Replace the Occupant Restraint Controller.
WARNING: If the occupant restraint controller is dropped at any time, it must be replaced.
- Perform AIRBAG VERIFICATION TEST. Airbag System Verification Test