1817-02

1817-02 REVERSE LAMP CIRCUIT SHORT TO VOLTAGE





When Monitored and Set Condition

- When Monitored: Always monitored with system active at each ignition cycle.
- Set Condition: If the SLA detects a short to voltage on the Reverse Lamp Supply circuit.






1. TEST REVERSE LAMP SUPPLY CIRCUIT SHORT TO VOLTAGE





Turn the ignition off.

Disconnect the Shift Lever Assembly harness connector.


NOTE: Check connector - Clean/repair as necessary.

Measure the voltage of the Reverse Lamp Supply circuit.

Is voltage present?

No

Replace the Shift Lever Assembly.

Yes

- Repair the Reverse Lamp Supply circuit for a short to voltage.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. Transmission Verification Test