P0306
P0306 - CYLINDER #6 MISFIRE
When Monitored and Set Condition
- When Monitored: Any time the engine is running, and the Target Learning Coefficient has been successfully updated.
- Set Condition: When more than a 1.0% misfire rate is measured during two trips.
Diagnostic Test
1. CHECK FOR CURRENT DTC
Turn the ignition on.
With the DRB III(R), read PCM DTCs.
Is this DTC present?
Yes
- For complete diagnosis of this DTC, refer to (P0301) CYLINDER #1 MISFIRE P0301
No
- Go To 2
2. INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
NOTE: Check connectors - Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the wires while checking for shorts and open circuits.
NOTE: Check for any Technical Service Bulletins that may apply.
Were there any problems found?
Yes
- Repair as necessary.
- Perform POWERTRAIN VERIFICATION TEST - VER 2. Powertrain Verification Test - Ver 2
No
- The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible intermittent condition.